The Dipmeter tool is a formation strike and dip directional probe
primarily used in mining and environmental logging applications.
Additionally, the tool also records natural gamma, X-Y calipers, and
borehole deviation is computed from the slant angle and bearing
measurements calculated from the inclinometer and magnetometer
sensors. To ensure accurate strike and dip measurements in small-
diameter holes, special care should be taken when calibrating the calipers
to maximize their accuracy.
FEATURES
Properties Measured
1. Natural Gamma:
2.2 x 8.9 cm (0.875 x 3.5 in.)
NaI (TI) Scintillation
Offset: 14 cm (5.5 in.)
2. Slant Angle Bearing:
Offset: 67 cm (26.4 in.)
3. Independent X-Y Calipers:
Maximum 30 cm (12 in.) Hole Diameter
Offset: 305 cm (120 in.)
4. 4-pad Micro Resistance:
Offset: 305 cm (120 in.)
Length: 323 cm (127 in.)
Temperature: 85 C (185 F)
Diameter: 57 mm (2.25 in.)
Pressure: 352 kg/cm2 (5000 PSI)
Weight: 34.6 kg (76 lb.)
Logging Speed:
Maximum: 5.5 m/min. (18 ft./min.)
Minimum: 2.7 m/min. (9 ft./min.)
Tool Voltage Required: 115 VDC
TOOL#: 9411
